Most Popular Parts
These are the most commonly purchased repair parts for ADE20L1H.
-
This screw is sold individually.
-
The blower wheel clamp is used to hold the blower wheel to the motor shaft. The clamp is less than an inch long and is used with your dryer. If your blower wheel is loose or making a noise while operating, you may need to replace the clamp. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.
-
(1)
Does not include the seal
-
(2)
This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.
-
This is the replacement motor pulley for your dryer. The motor pulley transfers momentum from the drive motor to the drum via the drive belt. If the motor pulley cracks or is no longer staying on the drive shaft, you will need to replace it. You will need to access the dryer motor for this repair, by removing the front panel. The motor pulley is approximately 1 inch in diameter and is sold individually. This is an OEM part sourced directly from the manufacturer.
-
Pad has adhesive backing.