Most Popular Parts
These are the most commonly purchased repair parts for DU915PWPQ1.
-
(18)
This gray rack track stop is used for your upper dish rack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.
-
(5)
This part will fit between the newer type lower wash arm and the wash arm retainer nut of your dishwasher.
-
(2)
If your dishwasher is leaking during use you may need to replace the gasket. The door gasket wraps around the sides and top of the dishwasher door and provides a waterproof seal between the tub and the door. It is gray in color and made of rubber. Once you have installed the door gasket it is recommend to close the dishwasher door and leave it closed for a few hours to make sure the door gasket properly seals. This is a genuine OEM part.
-
(3)
This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking and helps with the proper draining of the dishwasher.
-
(4)
-
(3)
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. NOTE: As per the manufacture this part has been updated from the original part. It may be a different color, and you may need to order an elbow (# W10685193) for the new designed valve to work.