Most Popular Parts
These are the most commonly purchased repair parts for E30EW7CESS2.
-
(4)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(3)
This 3400-watt bake element has screw style connections. The bake element is located on the bottom of the oven cavity and supplies the heat for baking. If your oven is not heating evenly, element will not heat, or there is little to no heat when baking, you may need to replace the element. When replacing the element make sure to hold the wires forward so the wires do not fall back through the rear of the oven. This is a genuine OEM bake element. Please remember to disconnect the power to your range before you start your repair.
-
(1)
This terminal block kit (also called terminal boards or strips) provides a convenient means of connecting individual electrical wires. This kit includes mounting screws and hex nuts and can be used with dryers and ranges. This kit allows you to attach the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to operate properly. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
This washer works in conjunction with the oven door handle to secure the oven door together. The washer measures 3/4-inch x 1/4-inch, is made of metal and is sold individually. This is a genuine OEM part.
-
The convection fan blade works in conjunction with the convection fan motor by turning to circulate the hot air through the oven for even heating. The fan blade attaches to the convection motor shaft and is secured by the blade nut. If the part is damaged or worn you will need to replace it. This part is made from metal and measures approximately 5” in diameter. Please remember to disconnect the power to the oven before starting your repair. This is a genuine OEM part and is sold individually.
-
