Most Popular Parts
These are the most commonly purchased repair parts for EER2000M02WW.
-
(13)
The bake element provides heat for baking and is located on the bottom of the oven. This part measures approximately 20-inch in length, 18-inch wide and is made of metal. If your bake element has shorted out, has arcing, makes the oven too hot, is not heating properly or has little to no heat, you may need to replace it. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. Please remember to disconnect the power before starting your repair. This is a genuine OEM bake element.
-
(8)
This part is also known as the "brains" of the appliance. ***NOTE: The wiring could be different than the original control. This part may need to be installed by an appliance repair person.
-
(6)
This is a replacement haliant element for your cooktop or range. It is used with flat top ranges, and is found under the glass top of the range. This element is approximately 12 inches in diameter and is sold individually. The haliant surface element supplies the heat needed to the top of the cooktop. If your burner is not lighting up when it is turned on, you may have an issue with the haliant surface element. Be sure to disconnect power to the range before you begin this repair. To replace the element, remove the screws holding the cooktop in place, then remove it. Then, remove the screws holding the burner in place, disconnect the wires and replace the burner. Replace the cooktop and screw it back in to complete the repair.
-
(7)
The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. The sensor is usually located in the back of the oven. This is a genuine OEM part. Please make sure to disconnect the power to your range before starting your repair.
-
(3)
This radiant stovetop element, or burner, is a genuine replacement part, and is 8 inches in diameter. The radiant element heats your cookware as you prepare food on the stovetop. To complete this repair, you will need a screwdriver to remove the screws holding the cooktop in place. Lift the cooktop up, and remove the screw and clip holding the old burner in place. Replace with the new element.
-
(3)
This part is the replacement surface burner switch or element control switch for your range or cooktop. The burner switch turns the surface element on and off and controls the amount of heat the element produces. If you are unable to start your heating element, or if the temperature is unpredictable, you may have a damaged surface burner switch. Be sure to disconnect your range from the power source or shut off the circuit breaker before repairing this part. It is sold individually and is an OEM part sourced directly from the manufacturer.