Most Popular Parts
These are the most commonly purchased repair parts for GRCR3820ZWW-1.
-
(2)
This is a large dual haliant element with a limiter or sensor for glass cooktops and freestanding ranges. It is a 2500-watt part. The inner diameter measures 9 inches, while the outer diameter measures 10 inches. If there is no heat generated from your element, you may need to replace this part. You may also need to check your socket or infinite switch. It is located under the glass cooktop of your appliance. Be sure to unplug or cut the circuit breaker to your appliance before starting this repair. Before replacing this part, be sure your appliance is getting enough power. If it is receiving less than the required 220 volts of alternating current, the surface element will not work.
-
(3)
This oven handle end cap connects to your oven door handle, and acts as the joint that connects it to the oven door. This part is made of black plastic and can be used as the left or right-side end cap. If your oven door handle is loose or disconnected, this part may fix the problem. The end cap will need to be screwed into the oven door itself, but simply snaps in to the door handle. This part is sold individually.
-
(1)
The oven bulb lens cover is made of glass and is approximately 2.75 inches in diameter. The lens cover protects the light bulb from being damaged. If the lens is cracked, damaged, or missing it will need to be replaced. It is suggested to make sure that the lens cover is cool to the touch before you start this repair. To remove the bulb lens cover simply slide the retaining clip off and then remove the lens. Replace it with a new cover and slide the retaining clip back on to hold it into place. This is an OEM part sourced from the manufacturer.
-
This is just the handle. The end caps for this handle must be ordered separately if needed.
-
-
(2)
This haliant burner element is a gneuine OEM replacement part for your stove. This element is 8 inches in diameter. The element lies underneath the stovetop, and will need to be replaced if it stops heating. To complete this repair you will need a 1/4 inch nut driver and a flat blade screwdriver. To access the element, open the oven door and unscrew the two screws under the lip of the cooktop.