Most Popular Parts
These are the most commonly purchased repair parts for JBP23DR2WW.
-
(2)
This 6-inch chrome drip bowl measures about eight inches in diameter at the widest point at the top. This drip bowl is used to catch any drippings or food that falls/spills while cooking. This chrome drip bowl is compatible with most electric ranges that utilize plug-in surface burners. If the drip bowl becomes rusted or damaged, you should replace it to avoid any grease or food that could drop down inside the range. This is a genuine OEM part and is sold individually.
-
(9)
This eight inch drip bowl is chrome in color and measures approximately 10 inches in diameter at the widest point. The drip bowl is used to catch anything that may spill over to make cleaning up a little quicker. Over time the drip bowl may become rusty, burnt, or worn down, and will need to be replaced. The drip bowl is a genuine OEM part and is sold individually.
-
(9)
The 8-inch surface element switch is also known as an infinite heat switch, and is a part for your range. It controls the large surface element. It will turn the element on and off, and allow you to change the heat intensity. The knob to adjust the heat setting mounts on the shaft of this swtich. The burner knob is sold separately. If your large surface element will not turn on, or you cannot adjust the heat intensity, you may have a broken or damaged surface burner switch. Be sure you disconnect your range from the power source before you begin this repair.
-
(8)
This part is also known as the "brains" of the appliance. ***NOTE: The wiring could be different than the original control. This part may need to be installed by an appliance repair person.
-
(1)
The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(4)
This broil element is found on the upper part of the oven cavity.