Most Popular Parts
These are the most commonly purchased repair parts for JVM1440WH03.
-
(5)
This 40 watt, 130-volt clear appliance light bulb is for your microwave. The light bulb is used on the inside of your microwave to provide light when the door is open or below the microwave to provide light for the cooking area. It is clear in color and has a small screw-in base. If your current bulb is burnt out or broken you will need to replace it. This bulb is a genuine OEM part and is sold individually.
-
(2)
The line fuse, also known as a ceramic fuse, is used to protect your microwave when there is a power serge by shutting down the microwave to avoid damage. If your microwave has no heat, won’t turn on, or the touch pad is not working properly, you may need to replace the fuse. This part measures approximately 1.25” long and is sold individually. Please remember to disconnect power to the microwave before starting the repair. This is a genuine OEM part.
-
(6)
This turntable motor coupler connects the turntable motor to the turntable tray to activate the tray. If your tray does not consistently turn or does not turn at all, replace this part. This part measures 1 1/2" in diameter. Remember to unplug your microwave from the power source as a safety precaution. Refer to the openers manual provided by the manufacturer for further installation instructions and accurate guidance.
-
(4)
The secondary door switch, also known as a micro switch, works in conjunction with your microwave by monitoring the door latch position and sending communication to the electronic control board to let it know if the latch is open or closed. When the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, the switch has failed, and the part will need to be replaced. You can test the switch for continuity. This part measures 1.5” L x .75” W. Due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge, even when unplugged, it is suggested to have a service technician install the part. Please disconnect power to the microwave before beginning the repair. This is a genuine OEM part.
-
(1)
The door interlock switch (normally closed) works in conjunction with your microwave operation. The switch will prohibit the microwave from starting when the microwave door is open. If your microwave won’t turn on or there is no heat you may need to replace the switch. This part measures 1.5” L x .75” W, 250 volts, is black in color with a red dot and is sold individually. Please remember to disconnect the power before starting your repair. This is a genuine OEM part.
-
Screws NOT included.