Most Popular Parts
These are the most commonly purchased repair parts for KDRP707RSS01.
-
(2)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(7)
The inner door glass forms a see-through heat barrier inside the oven door. When your oven door is closed, this glass is the innermost piece of glass. The glass measures 10” x 20”. This includes the glass only. It is recommended to wait until the glass is cool to touch before starting the repair. Make sure to wear gloves to protect your hands in case the glass breaks while removing it from the door. This is a genuine OEM part.
-
(2)
This broil element is for ranges.
Broil element is at the top of the oven and supplies the heat for broiling.
Disconnect electrical power to the range before installing this part. Wear work gloves to protect your hands.
-
This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.
-
This 5-watt 12-volt halogen light bulb provides light in the oven cavity when the door is open or the switch is turned on. The light assembly is a little over 1” long. If the light is not coming on the bulb may be burnt out or the socket has failed and will need to be replaced. This is a genuine OEM part and is sold individually.
-
This part is the replacement door gasket for your oven. It is made of gray rubber and is sold individually. The door gasket runs along the circumference of the oven door and creates a seal that insulates the oven and keeps heat in. If your oven will not heat up properly, or if you notice that the door gasket has become loose or worn, it may need to be replaced. To replace the door gasket, you will need to remove the retaining bracket at the bottom of the oven door, then carefully pull the gasket away from the front of the oven cavity. Then, push the new gasket inside the groove on the outside of the oven cavity, securing it with the arrowhead fasteners that are built in to the oven cavity. This is an OEM part from the manufacturer.