Most Popular Parts
These are the most commonly purchased repair parts for KUDS30FBSS1.
-
(53)
The lower rack wheel assembly attaches to the rack to allow you to slide the rack in and out easily. The wheel is gray in color, made of plastic, and approximately 6 inches long. This rack wheel assembly is a genuine OEM part and is sold individually.
-
(59)
The rack adjuster connects to the dishrack and is used to change the height of the rack. This kit includes the parts to replace the left and right-side rack adjusters and has been upgraded to a more durable metal design. This kit includes 2 adjuster assemblies, 1 left-hand and 1 right-hand actuator cover, 2 gray adjuster covers, and 2 gray adjuster housings. The most common symptoms linked with faulty rack adjusters include: leaking, door latch failure, door not closing, dishes not cleaning properly, and failure to start the washing cycle. It is recommended to replace both the right and left side adjusters at the same time.This is a genuine OEM part.
-
(9)
This genuine OEM Whirlpool lower dishrack is used to hold the dishes in place during the operation of the cycles. The lower rack is gray in color and includes the rack only. You can remove the rollers from the old rack and use them on the new dish rack.
-
(22)
The door balance kit helps support the weight of the dishwasher door while it opens and closes. If the spring to the door is damaged/broken or the door is not opening and closing properly you will need to replace this part. This door kit includes 2 door balance links and 2 door balance mounts with wheels for the left and right side of the door. This is a genuine OEM part.
-
(2)
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
-
Also known as rack adjuster. Sold individually.
This is an original part from KitchenAid, Kenmore, Whirlpool, Jenn-Air, and Maytag for use with Dishwashers. The dishrack adjuster arm positioner clip holds the adjuster arm in the right position on the dishrack. The most common reason for replacing the strap is if the rack will not stay in its desired position. This part is sold individually. There are no tools needed to replace the positioner.