Most Popular Parts
These are the most commonly purchased repair parts for MAV7000AWQ.
-
(2)
This motor is a 2 speed, 1/2 HP, 120V, 60Hz.
-
(2)
This drain pump with pulley has 2 ports. The pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. If your washer will not drain, is noisy, leaking or has a burning smell, you may need to replace the drain pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(1)
This washing machine drive belt is used with some clothes washers. This belt is all black in color and is made entirely of rubber.
-
This kit includes the lid switch and the plunger. The pin on the lid pushes on the lever of the switch to tell the machine that the lid is closed.
-
The transmission pulley and bearing kit, also known as a thrust bearing kit, is located on the drive shaft. If your washer won’t agitate during use, drum won’t drain, or there is a loud noise during operation, you may need to replace this part. A worn bearing also causes slow spinning or no spin at all. This kit includes the pulley that rotates to spin the tub, washer, and thrust bearing that fits between the pulley and the transmission shaft, 2 upper race washers, 1 lower race washer and the instruction sheet. This is a genuine OEM kit; the parts are not available separately. Please remember to disconnect the power and water supply to the washer before starting the repair.
-
(1)
The tub-to-pump hose is a flexible drain hose that connects the outer tub to the pump to carry the water from the tub to the drain pump. This hose is black in color, is made of plastic and measures approximately 17” long with a 1 1/2” diameter. If the hose becomes clogged, broken, or cracked, it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before you start this repair.