Most Popular Parts
These are the most commonly purchased repair parts for WERP4120SQ2.
-
(11)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
This temperature sensor detects the temperature within the oven cavity. This oven temperature sensor, for ranges, works together with the oven control board to measure and regulate the oven temperature. The sensor detects the temperature in the oven cavity. If the following symptoms occur, replacing the temperature sensor could be the solution: Little or no heat when baking, oven not heating evenly, oven will not start, and/or oven is overheating. Often, if the sensor is defective, the oven temperature will fluctuate and be inaccurate by more than 50 degrees. The tool needed for this replacement is a #2 square head screwdriver or a #2 Philips screwdriver. Remember to unplug the range before installing the part.
-
(5)
This 6 Inch 1200-watt radiant surface element with limiter is located under the main cooktop. When the element is turned on, it will heat up and provide heat to the cooking area on top of the range. If your element will not supply heat you will need to replace it. When replacing the radiant surface element please make sure the element is cool to touch before starting the repair. Disconnect the power to your range before beginning the repair. This is a genuine OEM part.
-
This switch controls the stove top 6" surface burner.
-
NOTE: The trim has been re-designed and no longer requires the screws. The dimples on the bottom hold them in place instead.
-
(2)
The large surface element is installed under the cooktop and heats up the area directly above it. It is approximately 10 inches in diameter and is 1200/2500 watts. If your element is not heating up, you may need to replace the element or check the burner switch. This part a genuine OEM part. Please remember to disconnect the power to your range before starting your repair.