Most Popular Parts
These are the most commonly purchased repair parts for WFW8300SW03.
-
(12)
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. It has two ports for water to pass through: a large one, and a smaller one. If your washer will not drain, is noisy, leaking, or pumps but will not spin you may need to replace the pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair. This pump also comes with a removable filter.
-
(1)
Also known as a door boot seal.This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
(3)
This part ensures that your door stays locked while the machine is running.
-
(2)
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature or amount of water needed.
-
(3)
This part is the replacement drive belt for your washer. It is made of black rubber and is approximately ½ an inch wide and 48 inches long. It has 6 grooves and is sold individually. The drive belt is found between the motor pulley and the drive pulley, and it connects the motor to the drive system. When the belt is running, it allows the basket or tub to spin. If the belt is stretched, worn, or broken, the tub will not turn. A warped belt can also cause the washer to be noisy while operating. This part is an authentic OEM part sourced directly from the manufacturer.