Crosley Refrigerator Hardware

Retaining Ring

Part Number: WP9703438

The retaining clip goes onto the end of the roller axle and holds the drum roller on to the axle. If the ring is broken or damaged, you will need to replace it. This is a genuine OEM part and is sold individually.

Single Washer

Part Number: 240311303

Sold Individually.

Screw

Part Number: WP681249

Sold individually.

Screw, 8/18 x 3/8

Part Number: WP90767

This screw is sold individually.

Screw

1 Review

Part Number: 218755504

Sold individually. This is a genuine part. The handle mounting shoulder screw (no.10 ab) is made for use with many refrigerators. The metal screw helps to fasten the handle assembly to the outer door panel. The handle mounting shoulder screw is sold individually. For the repair, you will need a pair of pliers.

Screw

1 Review

Part Number: 240521303

This small, Phillips-head screw works with your refrigerator/freezer. It screws in to the freezer door and connects to the door handle. This part is made of stainless steel and is sold individually. This is an OEM part sourced directly from the manufacturer.

Screw

Part Number: 218755402

10 - 32 x 0.375

Screw

Part Number: 215503203

Cross Recessed Pan Head Screw Size: 10-16 X 0.500

Hose Clamp

Part Number: WP596669

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Levers Retainer/Clip

Part Number: WP2194719

This part is the replacement dispenser lever retainer for your refrigerator. It is made of metal and is approximately 2 inches long and ½ an inch wide. The bottom half of the dispenser lever retainer holds in the pivot points of the ice and water arms. If it breaks, the arms will be loose and can shake around. The top half springs the ice and water arms back into the original position, and if the retainer is broken, they will not be able to do this. The dispenser lever retainer is found behind the dispenser trim and can be removed with a ¼ inch nut driver. This part is sold individually and is an OEM part.