Crosley Washer Hardware

Agitator Bolt

Part Number: WP358237

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

Screw, 8-16 x 1.000

Part Number: WP8533953

Sold individually.

Thrust Washer

Part Number: WP233520

This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.

Screw, 8/18 x 3/8

Part Number: WP90767

This screw is sold individually.

Single Spring with Insulators

1 Review

Part Number: 134144700

SCREW

Part Number: 131168200

Sold individually.

Screw

Part Number: 131302800

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Drive Belt - 6 ribs

1 Review

Part Number: 134051000

This is a drive belt for your washing machine. This part spins the basket in your appliance by connecting the drive motor to the drive system. You will need to replace the drive belt if your pumps are not spinning, your washer is not agitating, or you are noticing excess noise and/or a burning smell. This belt is black with six ribbings. To replace this part, you will need a Phillips screwdriver.

Suspension Spring Retainer

Part Number: WPW10145155

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

Cover Screw

Part Number: WP308685

Sold individually.