General Electric Washer Hardware

SCREW

Part Number: 131168200

Sold individually.

Screw

Part Number: 131302800

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Tub Bearing Washer

Part Number: WH2X1197

The tub bearing washer goes between the transmission and the tub bearing in your washer. This part helps to keep the inner tub spinning smoothly during operation. If your washer is noisy you may hear the bearing wearing on the transmission and the tub bearing washer will need to be replaced. This part is gray in color and measures approximately 2” in diameter. This is a genuine OEM part. Please disconnect the power and water supply to the washer before starting this repair.

Screw-In Plastic Leveling Leg

Part Number: 134548800

Sold individually.

Screw 8-16 hxw 1/2 Stainless Steel

Part Number: WD02X10067

Sold Individually.

SCREW #10

Part Number: WE2M163

Timer Knob Clip

1 Review

Part Number: WH1X2117

The timer clip is located on the back of the timer knob and helps secure the timer knob to the timer shaft allowing you to select the desired time setting for your dryer. If the knob has become loose or the clip is missing or broken, you will need to replace the clip. This clip is made of plastic and measures 1”. This is a genuine OEM part and is sold individually.

Hub Nut

Part Number: WH2X1193

This part is the hub nut, or lock down nut for your washing machine. It is designed to hold the inner tub on to the transmission. If your hub nut is stripped or damaged, it may need to be replaced. This hub nut is approximately 1.5 inches in diameter. This is an OEM part sourced directly from the manufacturer. You will need a hub nut wrench and some WD40 to loosen the nut and remove it from the agitator shaft.

Hub Nut

Part Number: WH01X10618

This hub nut is a genuine OEM replacement part for your stackable washing machine. Removing the hub nut may require a spanner wrench, as per the manufacturer specifications. Replacing this part requires some disassembly of the agitator assembly. The nut should be turned clockwise to remove it.

Drain Hose Clip

Part Number: WH16X513

This clip holds the drain hose to the back of the washer.