999L30XG Kenmore Dryer Parts List

Dryer radiant flame sensor (gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly.)

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

Screw, 8-18 x 1/2 (screw, 10-16 x 5/16")

This screw is sold individually.

K-series ignition coil kit ('k' series ignition coil kit)

This 'K' series ignition coil kit contains three coils - one secondary coil, one holding coil, and one booster coil. The holding coil sits on top of the booster coil on the same post. If the igniter glows but there is little to no flame or your clothes won't dry, then you have to replace these coils.

Booster coil (booster coil kit for gas valve, used with holding c)

Ignitor (igniter, will replace round style only)

This igniter can only be used in place of round style igniters. This part ignites the gas within the dryer.

'k' series ignition coil kit (gas valve solenoid kit (3 coils) complete with wire harness connector and seals)

This gas valve ignition coil kit is made for use with Amana/Speed Queen brand Rodger style gas clothes dryers. It comes complete with a wire harness connector and seals.

Nut,hex 5/16-18

Plug,block-open

Lockwasher

Shut-off valve

Discontinued

Discontinued

Discontinued

Latch (key,panel-hmv-10)

Key,panel-hmv-10

Assy,wiring harness a