Maytag Washer Bearings

Transmission Pulley and Bearing Kit

Part Number: 12002213

The transmission pulley and bearing kit, also known as a thrust bearing kit, is located on the drive shaft. If your washer won’t agitate during use, drum won’t drain, or there is a loud noise during operation, you may need to replace this part. A worn bearing also causes slow spinning or no spin at all. This kit includes the pulley that rotates to spin the tub, washer, and thrust bearing that fits between the pulley and the transmission shaft, 2 upper race washers, 1 lower race washer and the instruction sheet. This is a genuine OEM kit; the parts are not available separately. Please remember to disconnect the power and water supply to the washer before starting the repair.

Tub Seal and Bearing Kit

3 Reviews

Part Number: W10435302

This kit includes the shaft, 3 bearings, seals , grease, adhesive and the spanner nut, which is NOT sold separately. Also may require a bearing driver tool to install. PS3503307

Spin Tube Bearing

Part Number: WP8546462

This spin tube T-Bearing is an inch long. Sold individually.

Ring, Thrust

Part Number: WP62658

Centerpost Bearing and Seal Assembly

1 Review

Part Number: 285203

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Rear Bearing

Part Number: WP22003441

This part is located near the tub's brake assembly.

Main Tub Bearing Assembly

1 Review

Part Number: WP40004201P

This triangular main tub bearing assembly is five inches long. It is made of metal.

Upper/Lower Bearing

Part Number: WP40004001

Bearing only.

BEARING

Part Number: W10293230

BEARING

Part Number: W10653983