BCS42ELE GE Refrigerator Parts List

Dual inlet water valve (dual water inlet valve kit. New, quick connections. Cut retaining nuts off of existing plastic water lines and gently push them into new valve.)

This valve comes with 1/4" compression inlet. NOTE: This part comes with new quick connections. To install - cut retaining nuts off of existing plastic water lines and gently push them into new valve. To remove - depress ring that the tube slides into.

Run capacitor (refrigerator run capacitor 12 uf. If this run capacitor is defective, the refrigerator will not run.)

The run capacitor is attached to the compressor and is 12 UF. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Condenser fan motor - 115v (refrigerator condenser fan motor. 3 round pin connection terminals. The condenser fan motor draws air though the condenser coils and over the compress)

This part comes with 3 round pin connection terminals. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

Defrost timer (defrost timer. Turn the dial on the timer clockwise to advance it into and out of defrost.)

This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.

Evaporator fan motor kit (evaporator fan motor assembly)

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.

Drawer slide rail - right side (right hand drawer slide)

Plastic tube - 1/4 inch (plastic tubing- 1/4")

Power cord (power cord assembly)

Relay ptcr - 2 wire (start relay)

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

Mounting grommet (grommet mtg.)

The mounting grommet is used to hold the compressor in place to avoid vibration. The part is made of plastic and is black in color. This is a genuine OEM part that is sold individually. It measures 1 inch in diameter.

Defrost thermostat kit (defrost thermostat kit with wires, l45-20, brackets, and crimp-style wire connectors)

This defrost thermostat kit comes with the installation with wires, mounting brackets, and wire connectors. L45-20.

De-icing kit (icing kit with insulation)

This part should be installed by an appliance repair person as it could be dangerous. This part may be used to help prevent your evaporator fan from becoming blocked with ice. This part also insulates the evaporator coil area so you don't get a buildup of ice in the damper area.

Clip

This clip helps to hold the compressor in place.

Fan blade with clamp (evaporator fan blade with spring clamp)

This blade attaches to the evaporator motor.

Defrost heater (defrost heater assembly)