CE30M2WFAA Tappan Range Parts List

Drip bowl - 8" (chrome drip bowl (also called a drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the bu)

The eight-inch drip bowl sits under the surface burner element to collect anything that may drip or spill over, to make cleaning up quick. This bowl measures approximately 10-inch in diameter at its widest point at the top. If your drip bowl becomes damaged or rusted it is best to replace the drip bowl to avoid any grease or spills from dripping down inside the range. This chrome drip bowl is compatible with most electric ranges that utilize plug-in surface burners. This is a genuine OEM part and is sold individually.

Bake element - 240v (oven bake heating element with push-on wire terminals. If the oven won't heat, the bake element may have burned out. Often, if the bake element has bu)

This heating element is a partially open-style bake element. Carrying 240V and 2000W, it is 19-1/4" wide by 15" long. The two 90-degree push-on male spade terminals are 13-3/4" apart.

Surface element - 8 inch - 220v (stove top coil surface heating element, 8 inch. If the element does not heat either it or the control switch is defective. The coil can be tested to d)

The coil burner element is eight inches in diameter. It has four turns, 220 volts and looped terminal ends. The coil burner element provides heat to the cooking surface on your range. You might need to replace this part if your element is not heating. It might have shorted out around the coil or the terminal block; you can test the coil to see if the burner or the switch may be at fault. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.

Drip bowl - 6" (chrome drip bowl for 6-inch burner. This drip bowl sits underneath the burner to catch drips or spills.)

This six-inch heavy chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl has a narrow 3/8-inch lip. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Surface element - 6 inch (range/stove surface element (6-inch). If the surface element won't heat, either the surface element or the surface element switch may be defective.)

The standard Y-frame 6” surface element supplies heat to the cooking surface on your range and is a genuine OEM part. It has a black center medallion and looped terminal end. If your element is not heating, shorted out around the coil or if the terminal block shorted out and burnt out the contacts on the end, you may need to replace the element. Please be sure to disconnect the power to your range before starting your repair. Note: The manufacturer suggests replacing the receptacle at the same time.

Main terminal block kit (terminal block kit for electric range and dryer power cords.)

This terminal block kit (also called terminal boards or strips) provides a convenient means of connecting individual electrical wires. This kit includes mounting screws and hex nuts and can be used with dryers and ranges. This kit allows you to attach the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to operate properly. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Broiler pan grate insert (broiler pan and insert)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Broil element (oven broiler heating element with push-on terminals)

This fully open fixed oven broil element carries 240 volts and 2750 watts.

2 pack light bulb - 40w

Door switch (door/light switch)

The oven door switch is a on an off mechanism that will shut the oven light off when the oven door is closed. When you open your oven door and the light does not come on, it could be the switch or the light bulb and one of them will need to be replaced. The switch is black in color, has two terminals and is a little over 2” in length. This switch is a genuine OEM part. Please remember to disconnect the power to the oven before starting the repair.

Hinge (hinge arm, oven door)

Spring-oven door

Handle-drawer/door (drawer/door handle)

Rack (oven rack)

Indicator light kit - 125v (indicator light kit)