DLL1550AAL Hotpoint Dryer Parts List

Drive belt (dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time.)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Idler pulley wheel (idler pulley wheel with spacer and retainer clip)

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Gas igniter (gas dryer igniter, round style. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the dryer will not heat.)

Be very careful to not handle the igniter by its gray part. Hold it by its white tip only.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Door switch (dryer door switch, 3-wire. Use the two smaller terminals for models with only two wires to the switch (no drum light).)

This part has three terminals. Note: Use the two smaller terminals for models that only have two wires to the switch.

Heat detector (flame sensor assembly for gas dryer)

Also known as Flame Sensor/Detector.

Start switch (motor centrifugal switch for "t" style motor)

Motor pulley with screws (motor pulley with set screw)

Thermostat (high limit thermostat, l300-40f)

Thermostat (low cycling thermostat, l135-10f)

Thermo assembly (cycling thermostat kit, l150-15f)

Thermostat (oven thermostat)

Discontinued (rotary switch)

Discontinued (motor centrifugal switch for "r" style motor)

Discontinued (rotary sw)