FFT7589-87B Parts List

Rear drum bearing kit (dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate.)

This rear drum bearing kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant, and installation screws. The support bearing helps support the dryer drum to rotate quietly and smoothly during operation. The bearing attaches on the inside of the rear panel of the dryer cabinet. Over time the drum bearing will wear out. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Upper drum glide (front upper felt glide pad. Includes nylon glides, adhesive, and installation instructions. These drum glides help to support the front of the dryer d)

The upper drum felt glide kit helps to support the front drum as it rotates smoothly and quietly while operating. This kit includes three glides with the adhesive. If your dryer won’t tumble or is noisy, the glide could be worn down causing you to hear a metal on metal noise and will need to be replaced. The drum glide is a genuine OEM part and sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Lint screen and frame (lint filter screen and mounting frame)

This filter collects lint as it passes through the dryer vent.

Thermal limiter - limit 220 (dryer thermal limiter (or thermal fuse). Located on the blower housing. If the dryer overheats, the thermal fuse blows to cut off power to the dryer.)

This thermal fuse limiter, with a limit of 220 degrees Fahrenheit, is manufactured for both gas and electric clothes dryers. Once the internal temperature of the dryer reaches 220 degrees, the heating element cuts out. If your dryer overheats, will not start, takes too long to dry, or has no heat or not enough heat, you will need to replace the fuse because it cannot be reset. This is a genuine OEM part. It is recommended to disconnect the power to your dryer before starting your repair.

Flat style belt (dryer drum drive belt. 87 3/4 inches long and 1/2 inch wide. This drive belt wraps all the way around the dryer drum, around a tension pulley, and the)

This is a flat style ridgeless dryer belt.

Idler pulley assembly (idler tension pulley with bracket for dryer drum belt)

The idler pulley assembly provides the tension required for a flat belt. It also serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel. If your dryer is noisy or will not tumble you may need to replace the idler pulley. This is a genuine OEM part.

Door latch kit (dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.)

This door latch kit comes with the strike and the catch.

Front drum seal (front lower felt seal, drum)

Used with dryers with a 27-inch drum.

High temperature adhesive (high temperature adhesive for installing rubber and felt seals)

The high temperature adhesive is used to create a heat resistant bond between felt seals and rubber gaskets on your appliance. This adhesive is made to withstand hot temperatures. This tube contains one ounce of adhesive. Before starting your repair, it is recommended to wear gloves and ensure that your working area is clean and dry.

Terminal block kit (dryer terminal block repair kit. For power cord connection.)

This kit includes 3 screws and 3 terminals.

Cycling thermostat - 4 terminal (cycling thermostat with bias heater, l140-10f)

L140-10F

Heating element coil kit (heating element with ceramic spacers)

This kit includes the heating element restring coil, 2 insulators and a terminal block.

Safety thermostat - l285-40f (safety thermostat, l285-40f)

This part acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Glide n' guard

Rotary knob - chrome (timer knob, chrome)

Sold individually.