LC248DW4 Frigidaire Washer Dryer Combo Parts List

Water inlet valve (water inlet valve. The water inlet valve opens to allow hot, cold or warm water to enter the washing machine.)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.

Main terminal block kit (terminal block kit for electric range and dryer power cords.)

This terminal block kit (also called terminal boards or strips) provides a convenient means of connecting individual electrical wires. This kit includes mounting screws and hex nuts and can be used with dryers and ranges. This kit allows you to attach the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to operate properly. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Lint filter (slide-in lint filter)

V-style belt (washing machine belt, length 31 1/2”, width 1/2”, characteristics, medium “v”- shaped, cloth covering)

This washing machine v-shaped belt is cloth covered.

Snubber ring (snubber ring for tri-base)

Mounts at the base under the support.

Transmission to tub seal kit (washing machine tub seal kit, complete with instructions)

Transmission assembly (washer replacement transmission kit. If the washer does not agitate, but the motor and belt engage the tranmission then the tranmission has likely fai)

This part aids in the spinning and agitating cycles. The length of the shaft on this part is 13". The seal/gaskets are NOT included.

Pump w/adhesive (drain pump kit)

Dryer drum belt (dryer drum drive belt, belt length 78.50”, width 1/4”, characteristics, 3 ridges, flat)

This belt is flat with 3 ridges and length of 78.50” and width 1/4”.

Thermostat (thermostat heater assembly)

Lint filter housing (internal vent duct with installation hardware)

Comes with installation hardware.

Heater assembly (heating element assembly, 240 volt)

Seal (drum felt seal kit)

Discontinued (dryer motor)

Thermstat-control (thermostat, l145-15)