Hose Clamp

Part Number: WP596669

This washing machine hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Humidistat Kit

Part Number: WP1166055

Hex Nut

Part Number: WP488130

This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.

Water Inlet Hose Washer

Part Number: WP16123

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Filter Drier Tube

Part Number: W10843121

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

Float

(1)

Part Number: 5303306080

This black water bucket float works in conjunction with dehumidifiers. The bucket float helps monitor the water level within the dehumidifier water bucket to prevent the bucket from over flowing. When the water level reaches the maximum level, the bucket float will signal the switch to stop the dehumidifier to prevent the water bucket spilling on to the floor. If there is water on the floor the water bucket is overflowing, you will need to replace the float. This part is made of plastic and measures approximately 4”. This is a genuine OEM part. Please remember to disconnect the power to the dehumidifier before starting the repair.

Float

Part Number: WP1172075

The float is used to help monitor the water level inside of the dehumidifier bucket to prevent water from overflowing onto the floor. Once the water level reaches the maximum in the bucket, the float will signal the float switch to shut down the dehumidifier to avoid the bucket from overflowing, causing water to spill on to your floor. If your bucket is overflowing you may need to replace the float. The float is black in color, made of plastic and measures approximately 4” long. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Humidistat Control

Part Number: 5303296823

The dehumidifier humidistat control will sense the humidity level, once the set level humidity drops the humidistat will shut off the dehumidifier. This humidistat control will need to be replaced if the dehumidifier will not shut off. This is a genuine OEM part. Please remember to disconnect the power to the dehumidifier when starting your repair.

Compressor Start Relay

Part Number: 216594300

The compressor start relay attaches to the compressor to help start the compressor motor and then shuts off as soon as the motor gets up to speed. The relay is black in color and measures approximately 1”. If your refrigerator is not running you may need to replace the relay. You can use a multimeter to check the continuity. The overload is not included with the start relay. The overload must be ordered separately. Please remember to disconnect the power before starting your repair. This is a genuine OEM compressor start relay.

Control Knob - White

Part Number: 1168687