Kenmore Dryer Elements and Burners

Heating Element - 240V 5400W

21 Reviews

Part Number: 279838

This 240V/5400W heating element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current, causing the wire to heat up. The heat produced is used to dry the clothes in your dryer. If the dryer has no heat, takes too long to dry, or the heating element burns out, the heating element will need to be replaced since it cannot be repaired. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Dryer Heating Element

10 Reviews

Part Number: WP3387747

Dryer Heater Element

5 Reviews

Part Number: WP8544771

Heating Element Assembly

5 Reviews

Part Number: 131553900

This E-line assembly comes with a felt strip and insulators already attached. Heating elements are strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer. If your dryer has little or no heat you may need to replace the heating element. This is a genuine OEM part. Please remember to shut off the power to the dryer before starting the repair.

Heating Element Connection Wire Kit

1 Review

Part Number: 279457

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

Heating Element - 5300W

1 Review

Part Number: DC47-00019A

Includes the insulators and restring already attached. This dryer heating element produces heat to dry clothes in a dryer and is located in the rear end. If the heater element is burned, dryer does not heat or over heats, or clothes take too long to dry, then replacing this part could solve your problem. The tools needed for this repair project are: Phillips screwdriver, putty knife, needle nose pliers. To repair, first remove the main top of dryer and remove ground strap at the rear. Next, disconnect two wire harnesses that hold front panel to the cabinet to pull out front panel. Once you have access to the inside of the dryer, refer to the manual for further installation instruction. As a safety precaution, remember to unplug appliance from power source before beginning this repair project.

Heating Element

6 Reviews

Part Number: WP4391960

The drum glide helps the front drum rotate smoothly and quietly while operating. If your dryer won’t tumble or is noisy, the glide could be worn down, causing a metal on metal noise. In this case it will need to be replaced. It is recommended to replace both glides at the same time and two is required for the dryer. The drum glide is a genuine OEM part and is sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Dryer Heater Element

1 Review

Part Number: 134792700

This 3-coil 5500 watts heating element with housing is used to produce heat to dry the clothes in your dryer. The heating element is strung with a coiled wired. The wire receives, but resists a controlled electric current causing the wire to heat up to dry your clothes. If there is no heat or it is taking too long to dry, you may need to replace the heating element. Check for a blown thermal fuse or thermal cut off. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Heater Assembly

2 Reviews

Part Number: 5301EL1001H

They are all strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer

Heater Assembly

1 Review

Part Number: 131475320

This dryer heating assembly has 5/16" terminal on the housing.