1069718280 Kenmore Refrigerator Parts List

Shelf support kit (shelf support pins, slide-on, set of 4)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Crisper drawer support - cut-to-fit (crisper support)

This part may be longer than the original - it might need to be cut to the correct size for your appliance.

Water inlet hose washer (washer for fill hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Touch-up paint - black (black appliance touch-up paint.)

16ml

Ice maker front cover (ice maker module front cover)

Cold control thermostat (thermostat, refrigerator. Note: Poor cooling problems are normally not the result of a thermostat problem.)

The cold control thermostat helps maintain the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process. If the refrigerator is too warm you may need to replace the control thermostat. This part has a temperature range from 29.5 degrees Fahrenheit to 16.5 degrees Fahrenheit and a capillary length of 35 inches. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Side hinge plate

Fresh food door gasket (door gasket)

This misty beige door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Touch-up paint - almond (almond touch-up paint)

Hinge sleeve hole plug - white (hinge sleeve hole plug, white)

Sold individually.

Water hose clamp (clamp, water tube)

These tube clamps are sold individually. The screw is not included.

Screw (screw no. 8 x 1/2)

Sold Individually.

Hinge washer (washer, door hinge, 11/64")

This part can be used on either side of the center door hinges for some refrigerators.

Adhesive cement (alumilastic cement)

Also known as Alumilastic Cement.