1068253080 Kenmore Freezer Parts List

Light bulb - 40w (bulb light)

This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Door cam - black (door closer lower cam)

The refrigerator uses a set of cams to help with the closing of the doors and help to keep them in position. These cams are mounted around the door pivot point and are made up of a series of ridges and valleys to help keep the door in position. If your refrigerator uses a door closer, the door should shut all by itself. This part is black in color, made of plastic, and is sold individually. This is a genuine OEM part. Note: As per the manufacturer a new screw is needed to mount the door cam. This door cam is sold individually.

Condenser fan motor kit (motor morrill)

This condenser fan motor is used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This part also helps to evaporate excess water in the drain pan. If your refrigerator/freezer section is too warm you may need to replace this part. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Door closing cam kit (door closer upper cam)

This door closing cam kit is intended for use with the bottom of refrigerator and freezer door hinges. The cam helps with the closing of the doors and to keep them slightly in position when opened.

Capacitor

The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Screw (screw 8x1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Evaporator fan motor kit (motor fan)

This refrigerator evaporator fan motor kit comes with a wiring harness and a four-inch push on fan blade.

Light socket kit (socket light)

The bulb is sold separately.

Screw (screw 10-32x23/32)

Sold individually.

Kickplate support clip (support grille)

Sold individually.

Single hex head screw (screw 8x1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Door gasket (gasket magnetic)

This door gasket is used to seal the freezer door when closed.

Speed nut (nut speed)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Thermostat kit (thermostat & barrier assembly)

Evaporator/drain pan (tray evaporator)

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.