1068322050 Kenmore Freezer Parts List

Light bulb - 40w (bulb, light)

This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Defrost timer (timer, defrost)

This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Door cam - black (door closer lower cam)

The refrigerator uses a set of cams to help with the closing of the doors and help to keep them in position. These cams are mounted around the door pivot point and are made up of a series of ridges and valleys to help keep the door in position. If your refrigerator uses a door closer, the door should shut all by itself. This part is black in color, made of plastic, and is sold individually. This is a genuine OEM part. Note: As per the manufacturer a new screw is needed to mount the door cam. This door cam is sold individually.

Condenser fan motor kit (motor, fan includes illus. 9, 11, 14)

This condenser fan motor is used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This part also helps to evaporate excess water in the drain pan. If your refrigerator/freezer section is too warm you may need to replace this part. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Door closing cam kit (door closer upper cam)

This door closing cam kit is intended for use with the bottom of refrigerator and freezer door hinges. The cam helps with the closing of the doors and to keep them slightly in position when opened.

Screw (screw, 8 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Freezer door key (key)

Sold individually.

Evaporator fan motor kit (motor, fan)

This refrigerator evaporator fan motor kit comes with a wiring harness and a four-inch push on fan blade.

Light socket kit (socket, light)

The bulb is sold separately.

Screw (screw, 10-32 x 3/4)

Sold individually.

Single hex head screw (screw, 8 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Retainer bar end cap (trim retainer)

Sold individually.

Door gasket (gasket, magnetic)

This door gasket is used to seal the freezer door when closed.

Speed nut (nut, speed)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Thermostat kit (thermostat & barrier assembly)