Parts for Kenmore Models 1069638282

Capacitor (production capacitor)

The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Easy Part #:: EAP11757023

Availability:: In Stock

Price:: $51.60

Stud-shelf (stud shelf 5)

This is a 12 piece kit.

Easy Part #:: EAP16730711

Availability:: In Stock

Price:: $25.64

Ice maker water fill tube kit (fitting)

The ice maker fill tube is used to supply water to the ice maker during the fill cycle and is located in the back wall of your refrigerator/freezer. The fill tube is 10-inches long and includes a compression nut and a tube insert. If the fill tube is cracked or leaking water you will need to replace it. This part is white in color, made of plastic, and is a genuine OEM part. Please remember to disconnect the power and shut off the water supply before starting your repair.

Easy Part #:: EAP11739222

Availability:: In Stock

Price:: $9.55

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Easy Part #:: EAP385132

Availability:: In Stock

Price:: $7.15

Bimetal defrost thermostat (bimetl-def)

This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

Easy Part #:: EAP11742474

Availability:: In Stock

Price:: $38.80

Evaporator fan motor kit (motor evaporator)

The evaporator fan motor is in the back of the freezer section and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. It is suggested to replace the thermistor when replacing the evaporator fan. This kit comes with two mounting grommets, two sleeves (not to be used on porcelain models), two #8 mounting screws, and a push-on fan blade. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.

Easy Part #:: EAP376645

Availability:: In Stock

Price:: $61.64

Add-on icemaker assembly (icemaker)

This icemaker kit comes with a flat plug, wiring harness, fill tube, water inlet valve, ice bin, mounting hardware, and instructions.

Easy Part #:: EAP317560

Availability:: In Stock

Price:: $80.78

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Easy Part #:: EAP11742721

Availability:: In Stock

Price:: $7.45

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Easy Part #:: EAP347819

Availability:: In Stock

Price:: $18.90

Door light switch (light switch)

The white door light switch is in the control panel section of your refrigerator. The light will turn on when you open the door. If the light doesn?t turn on when the door is open the contacts in the switch could be burnt out and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.