Parts for Kenmore Models 1069659710

Refrigerator crisper drawer (pan crisper)

The crisper drawer with humidity control allows you to adjust the humidity within the crisper. By adjusting the humidity, it will extend the life of your produce. The crisper drawer is made of clear plastic, measures 13 1/2” wide and 18 1/2” deep. The drawer does not include the white trim on the front. This is a genuine OEM part and is sold individually.

Easy Part #:: EAP11731260

Availability:: In Stock

Price:: $87.13

Defrost timer (timer)

This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Easy Part #:: EAP11723171

Availability:: In Stock

Price:: $32.57

Icemaker control assembly (motor mold)

This part is used to help tell the icemaker what to do - it turns the timing cams and the ejector blades. It also controls the heater, the water inlet valve, the cube size, and cube ejection. The control assembly is located under the white cover of the ice maker. If the ice maker is making too much ice or not making ice at all, you may need to replace the control assembly. The motor is not sold separately. This is a genuine OEM part. Please make sure you disconnect power to the refrigerator before starting your repair.

Easy Part #:: EAP2341896

Availability:: In Stock

Price:: $81.02

Refrigerator single water inlet valve (inlet valve)

The single water inlet valve is used to supply water to the water dispenser and the ice maker. The valve is 60Hz 120 Volts and 35 watts. If your ice maker isn’t producing ice or the water dispenser not dispensing water, the solenoid might have gone bad and will need to be replaced. This valve includes 1/4” tubing and a plastic union. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the refrigerator before starting the repair.

Easy Part #:: EAP11740365

Availability:: In Stock

Price:: $48.65

Refrigerator door switch (light switch)

Door switch turns the light off when you close the door.

Easy Part #:: EAP12728638

Availability:: In Stock

Price:: $32.07

Icemaker

This ice maker kit includes everything needed to install a new icemaker in your refrigerator if it did not originally come with one. The kit includes the ice maker, ice bin, inlet valve, fill tube, hardware, 4 wire harness, connector for freezer, and instructions. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair. Note: This part has been updated by the manufacturer, it may differ in appearance but will still function the same as the original.

Easy Part #:: EAP16660327

Availability:: In Stock

Price:: $117.91

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Easy Part #:: EAP385132

Availability:: In Stock

Price:: $7.15

Bimetal defrost thermostat (bimetl-def)

This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

Easy Part #:: EAP11742474

Availability:: In Stock

Price:: $38.80

Crisper drawer rail (track)

This part goes in the center of the crisper shelf and acts as a support.

Easy Part #:: EAP11738956

Availability:: In Stock

Price:: $24.22

End cap trim - white (endcap trim)

This part is the replacement end cap trim for your refrigerator. It is made of white plastic and is approximately 1 inch wide, 1 inch long, and ½ inch thick. This part can also be known as the shelf support retainer as it holds the shelf support in place. If the end cap trim is damaged, the shelf support may not remain in place and you will not be able to store items in your refrigerator door. To replace the end cap trim, carefully disconnect it from both the refrigerator door and the shelf support. Then, snap the new end cap trim into the shelf support and then to the door. This part is sold individually and is an authentic OEM part.

Easy Part #:: EAP11738929

Availability:: In Stock

Price:: $10.41

Condenser fan motor (motor-cond)

NOTE: As per the manufacture the part does not come threaded. A self tapping screw will need to be used to make threads.

Easy Part #:: EAP11723170

Availability:: In Stock

Price:: $157.88

Screw

Sold individually.

Easy Part #:: EAP11742744

Availability:: In Stock

Price:: $7.49

Ice mold

This ice cube mold and heater assembly has a flake resistant surface with separations that mold eight ice crescents and is used with modular style icemakers on some refrigerators. The mold heater is an electrical device that thaws the ice quickly, so it can be released from the icemaker mold. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair.

Easy Part #:: EAP11749915

Availability:: On Order

Price:: $130.58

Water fill cup and bearing (fill cup)

The ice maker fill cup and bearing dispenses the water into the ice mold during the fill cycle. If your ice maker is not making ice, is leaking, or the cup or bearing is cracked, you will need to replace this part. This part is three inches long, white in color, and is made of plastic. It is a genuine OEM part. Please remember to disconnect the power and water supply to your refrigerator before starting the repair.

Easy Part #:: EAP11743318

Availability:: In Stock

Price:: $33.67

Water tube kit (water tube)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.