11047761800 Kenmore Washer Parts List

Washer drain pump (water pump)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. It has two ports for water to pass through: a large one, and a smaller one. If your washer will not drain, is noisy, leaking, or pumps but will not spin you may need to replace the pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair. This pump also comes with a removable filter.

Washer door bellow (bellow)

Washing machine door hinge (hinge)

Shock absorber

Sold individually. These shock absorbers keep the washer from vigorous shaking during its cycles. This shock absorber is for washers. Shock absorber absorbs the vibrations and movements of the outer washer tub. Unplug the washer before installing this part. Wear work gloves to protect your hands.

Hose clamp (clamp)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Bellow to outer tub clamp (clamp)

Used to help hold your bellow in place on your washer.

Flowmeter

This part continually measures the amount of water entering the tub. It will make adjustments if too much or too little water is present.

Drive belt (belt)

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear. NOTE: Per Manufacture, belt measures 48.22" long uninstalled and the belt will stretch To 51.53" when installed.

Water level pressure switch (water level switch)

This part is able to sense the water level in the tub. When the water reaches the desired level, this switch stops the water from flowing in the tub and the washing program begins.

Door lock latch (latch)

This part ensures that your door stays locked while the machine is running.

Bellow clamp (clamp)

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow into place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

Hose clamp (clamp, hose)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Pump hose (hose)

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.

Drain hose

This hose goes from the drain pump to the back of the washer.

Drum drive pulley (pulley)

This drive pulley attaches to the back of the washers drum.