1105901300 Kenmore Washer Parts List

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Screw (no. 8-32 x 1/2 self tapping screw (4 req'd) (standard hardware item-may be purchased locally))

Sold individually.

Lockwasher (1/4 lock washer (standard hardware item - may be purchased locally.))

Stud- shaft (shaft stud)

Terminal, ring, 3/16 inch dia. Hole (eyelet terminal)

Seal (drain funnel gasket)

Washer (fibre washer)

Use wpl 487836 (#10-32 hex nut (standard hardware item - may be purchased locally.))

Use wpl 90196 (1/4-28 x 1/4 set screw (standard hardware item-may be purchased locally))

Ping, 3/32 x 1/2 cotter (3/32 x 1/2 cotter pin (standard hardware item-may be purchased locally))

Funnel, drain (alternate) (drain funnel)

Cap, agtitator (agitator cap assembly)

Sleeve, use w/87199 (agitator cap sleeve)

Washer, thurst (thrust washer)