1105902100 Kenmore Washer Parts List

Hose clamp (hose clamp the following three (3) parts are used on model 110.5902100 only.)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Clamp-motor (motor mounting clamp (2 req'd))

This clamp is used to secure the drive motor.

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Screw (no. 8-32 x 1/2 self tapping screw (4 req'd) (standard hardware item-may be purchased locally))

Sold individually.

Terminal (spade terminal)

Nut (5/16-18 hex nut (3 req'd) (standard hardware item-may be purchased locally))

Stud- shaft (shaft stud)

Screw (5/16-24 x 3/4 hex hd. Cap screw (12 req'd) (standard hardware item-may be purchased locally.))

BULK OF 100 PCS.

Seal (drain funnel gasket)

Use wpl 90196 (1/4-28 x 1/4 set screw (standard hardware item-may be purchased locally))

Ping, 3/32 x 1/2 cotter (3/32 x 1/2 cotter pin (standard hardware item-may be purchased locally))

Gear-agitr (agitator shaft gear)

ALSO ORDER 1 285036 AGITATOR

Funnel, drain (alternate) (drain funnel)

Cap, agtitator (agitator cap assembly)

Pin, cotter 1/8 x 1 (1/8 x 7/8 cotter pin (standard hardware item-may be purchased locally.))