1106110100 Kenmore Washer Dryer Combo Parts List

Screw, 8/18 x 3/8 (no. 8 x 3/8 screw (standard hardware item-may be purchased locally))

This screw is sold individually.

Hose clamp (clamp)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Front top lock

This part is used to secure the top panel to the cabinet. Sold individually.

Hose clamp (clamp)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Single hex head screw (no. 8-18 x 1/2 screw (standard hardware item-may be purchased locally))

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Oil seal kit for gearcase input shaft (seal)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Screw (no. 10-16 x 1/2 screw (standard hardware item-may be purchased locally))

This screw is sold individually.

Screw (no. 8-18 x 3/8 screw (standard hardware item-may be purchased locally))

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Water inlet hose washer (rubber washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Hose clamp (clamp)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Toe panel clip kit (clip)

Hex nut (no. 8-32 nut and washer (standard hardware item-may be purchased locally))

This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.

Water pressure hose - cut-to-fit (hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Clip (harness clip)

Wiring harness clip.

Screw (no. 10-16 x 1 screw (standard hardware item-may be purchased locally))

This screw is sold individually.