1106318740 Kenmore Dryer Parts List

Light bulb - 40w (lamp, drum)

This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Door catch kit (catch, door)

This door catch kit contains two door strikes and three door catches to service dryer doors that have one or two catches. Make sure to read the instructions to determine which one to use for your model. These parts keep the dryer door closed to allow the dryer to operate. If your door won't stay closed or will not start you may need to replace this part. This is a genuine OEM part.

Lid switch (switch, door)

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer will not start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Screw, 8/18 x 3/8 (screw, 8 x 3/8)

This screw is sold individually.

Dryer door switch actuator spring/lever (clip, door switch)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Cycling thermostat - limit 135/155 (thermostat-145 degrees)

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Cover screw (screw, 10-12 x 1/2)

Sold individually.

Front top lock (lock, front top)

This part is used to secure the top panel to the cabinet. Sold individually.

Single access panel clip (clip, hinge)

Sold individually.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Bearing and seal kit (seal, front drum)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clip, motor)

This clamp is used to secure the drive motor.

Toe panel clip kit (clip)

Seal-door (seal, door)

Adhesive sold separately.

Felt clip kit (bumper, rubber)

This kit includes 2 bumpers and 2 locking clips.