11078062801 Kenmore Dryer Parts List

Idler pulley wheel and arm (idler pulley)

The idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.

Drum support shaft - rear shaft with right hand threads (shaft)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Single front panel cip (clip)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Drum support roller shaft - right hand threads (shaft)

This shaft is for the front with right hand thread. Sold individually.

Lp gas con

This gas conversion kit is used to convert natural gas burners to liquid propane in dryers. If your dryer will not start, heat, or there is an unusual smell, replacing this part can be a solution to the problem. The tools needed for this repair project are: a putty knife, 5/16 inch nut driver, small flathead screwdriver, pliers, and a 3/8 inch wrench. As a safety precaution remember to unplug your dryer from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for further installation instructions and a detailed diagram.

Door seal with adhesive (door seal)

This part creates a seal around the door. High temperature adhesive is included.

Drum drive belt (belt)

This part is used to rotate the drum.

Screw, 8-18 x 1/2 (screw)

This screw is sold individually.

Dryer screw (screw)

11-16 x 3/4 Sold individually.

Washer

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Spring

Dryer felt seal (drum seal)

This is an OEM dryer felt seals and includes adhesive.

Dryer lint screen grille (outlet grill)

This part is the replacement lint screen grille for your dryer. It is made of white plastic and is approximately 21 inches by 7 inches. The lint screen grille fits inside the lint screen housing and prevents clothing from falling into the lint duct. The main reason you would want to replace the lint screen grille would be if it is cracked, damaged, or missing, as clothing may be able to slip into the lint duct. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Seal, outlet housing (seal)