11082694500 Kenmore Washer Parts List

Neutral drain kit (neutral, assembly)

Screw (screw, ground)

This screw is sold individually.

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (includes key no. 13, 14 & 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Seal-shaft (seal, oil)

Transmission shaft seal.

Inner tub filter plug kit (filter, plate (includes key no. 14))

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Lid switch actuator assembly (strike, lid)

This part is used to activate the lid switch when the lid opens/closes.

Switch, main drive motor

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Rear leveling foot (foot, rear)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Nut-push-in (nut, push-in)

Sold individually.

Shaft, agitator (complete) (gear, agitator)

This kit is used for direct drive washing machines and is found inside the gearcase.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Lid switch actuator (actuator, lid switch)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.