11088762791 Kenmore Washer Dryer Combo Parts List

Blower housing seal (seal, transistion duct to lint duct)

This part seals between the blower housing and the blower housing cover.

Switch, door

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Spring (spring, idler)

Lid switch kit (switch, lid)

The point of the lid switch is for the tub to stop spinning when the washer lid is opened.

Lint screen - white (screen, lint)

This filter collects lint as it passes through the dryer vent.

Single motor grommet (grommet, motor (4))

Sold Individually.

Screw (screw and washer)

Sold individually.

Capacitor, motor start

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Seal, outlet housing

Screw (screw 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Heating element (element, heater)

This part is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus 13, 14 and 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.