19025 Kenmore Trash Compactor Parts List

Single metallic shoulder screw - size: 8-32 x 3\8" (screw)

Sold Individually.

Drive motor (trash compactor replacement drive motor kit)

The drive motor operates the trash compactor press, also known as a ram, that helps compact the trash. When in use the drive motor will activate the press by turning the gears and a chain, causing it to lower into the trash, compact it and then raise back up. If your compactor is noisy or not compacting, you may need to replace the motor. This is a genuine OEM part. Please remember to disconnect the power to the trash compactor before starting the repair.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Touch-up paint - black (black appliance touch-up paint.)

16ml

Toeplate guard (plate, toe guard, black)

This part is located at the bottom of your appliance.

Light switch (three terminal fan/light door switch)

This part turns the light on/off as the door opens and closes.

Rotary nut (nut)

Touch-up paint - almond (almond touch-up paint)

Screw (self tapping screw 8-32)

This screw is sold individually. Size: 8-32 x 1/4 inch.

Container spring

This part is a container spring for your trash compactor. When you release the container latch the spring will push the container out slightly. The most common reason to replace the spring in your compactor is if the drawer is hard to open or close. Disconnect power to your trash compactor before starting your repair.

Trash compactor bag retainer (cam)

The bag retainer helps hold the bag in place inside the container.

Bearing (needle bearing for ram drive screw)

Sold individually.

Deodorant (stick-up air freshener (2-pack))

Bearing (thrust race)

Sold Individually.