1987802 Kenmore Beverage Parts List

Screw (screw, thumb)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Scoop

Rivet (clip)

Sold individually.

Ice maker water pump and motor (pump assembly water)

This part helps circulate water through the evaporator to form ice that will be cut into cubes.

Speed nut (nut, speed)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Compressor relay/overload kit (for replacement compressor)

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overload provides extra protection for the compressor motor.

Screw - #10 - 32x1/2 (screw)

Sold Individually.

Screw

Sold individually.

Ice grid cutter (frame, grid)

Used on freestanding ice makers.

Compressor start relay (relay)

The compressor start relay attaches to the compressor and helps start the compressor motor and then shuts off as soon as the motor gets up to speed. This part is black in color and measures approximately 1”. The overload is not included, it must be ordered separately. Please remember to disconnect the power before starting your repair. This is a genuine OEM part.

Filter drier tube (drier)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

Motor-pump (motor, pump)

Condenser fan motor kit (motor, fan)

This motor operates the fan to help circulate the air for cooling of the compressor and the coils. It also helps to evaporate the excess water located in the drain pan.

8-18 x .625 tr cr ab (screw)

Sold individually.

Valve-gas (valve, body)