198814834 Kenmore Beverage Parts List

Screw, 8/18 x 3/8 (screw)

This screw is sold individually.

Water tube kit (tube, plastic)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Scoop

Compression nut (nut)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Ice maker water pump and motor (pump, water (complete))

This part helps circulate water through the evaporator to form ice that will be cut into cubes.

Plastic tubing inserts - 4 included (insert)

These inserts are used with 1/4 inch plastic tubing.

Control thermostat (thermostat, evaporator)

This part helps prevent the evaporator from freezing over and also determines the thickness of the ice.

Cycling thermostat (thermostat, bin control)

Used in stand-alone ice makers. The cycling thermostat controls the activation of the icemaker ejection cycle.

Compressor relay/overload kit (overload (used w/original compressor))

Filter drier tube (drier)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

Screw

Sold individually.

Motor-pump (motor, pump)

Door-inner (door, inner bin)

Screw (thumbscrew)

Sold individually.

Condenser fan motor kit (motor, fan)

This motor operates the fan to help circulate the air for cooling of the compressor and the coils. It also helps to evaporate the excess water located in the drain pan.