1988804830 Kenmore Beverage Parts List

Scoop

Rivet (clip)

Sold individually.

Ice maker water pump and motor (pump water)

This part helps circulate water through the evaporator to form ice that will be cut into cubes.

Speed nut (nut speed furnished with motor)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Control thermostat (thermostat evaporator)

This part helps prevent the evaporator from freezing over and also determines the thickness of the ice.

Ice grid cutter (frame grid)

Used on freestanding ice makers.

Filter drier tube (drier)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

Screw (screw 8-32x1/4)

Sold individually.

Motor-pump (motor pump)

Screw (thumbscrew 10x1/2)

Sold individually.

Condenser fan motor kit (motor fan)

This motor operates the fan to help circulate the air for cooling of the compressor and the coils. It also helps to evaporate the excess water located in the drain pan.

Valve-gas (valve body)

Plug

Screw (screw 8-32x1/2)

Sold individually.

Screw (screw 8-15x3/4)

Sold individually.