22302 Parts List

Replacement ice maker (refrigerator ice maker)

This is a replacement ice maker assembly. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold in to the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part. NOTE: This part has been updated by the manufacturer and does not include the cover, ice level arm or the wire harness. You can reuse those from the original ice maker.

Grease filter (grease filter for jenn air downdraft vent hood.)

This grease filter is intended for use with some downdraft cooktops and ranges to collect grease particles in the air from cooking. The grease filter is chrome in color, approximately fourteen inches long and almost twelve inches wide. The grease filter is sold individually and is a genuine OEM part.

Surface burner knob (range/stove surface burner knob. Fits burner control switch with 'd' shaped shaft.)

This surface burner knob is two inches in diameter. It is a black knob with a chrome trim, and white numbering denoting the temperature level of the surface burner. Sold individually. This knob accepts a D-shaped shaft.

Screw (refrigerator screw)

Sold individually.

Condenser fan motor kit (refrigerator condenser fan)

This condenser fan motor is used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This part also helps to evaporate excess water in the drain pan. If your refrigerator/freezer section is too warm you may need to replace this part. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Capacitor (refrigerator run capacitor)

The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Infinite switch (surface burner control switch, double flat shaft, nut mounted)

Screw (refrigerator screw)

This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.

Defrost heater - 500w 115v (refrigerator defrost heater)

This set includes two nine and a quarter inch radiant glass defrost heaters joined together with wire. Each heater carries 500 watts and 115 volts. The defrost heater heats the evaporator in the defrost mode of operation to keep the cooling coils from frosting over.

Hose clamp (dishwasher drain hose clamp)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Single outlet water valve kit (refrigerator water inlet valve)

When energized, the water inlet valve will release water from the supply line into the ice mold and the water dispenser in the refrigerator. If the ice maker is not making/dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. The water inlet valve is in the back section of your refrigerator and will need to be pulled out from the wall. Make sure to disconnect both the water and power supply before starting your repair. The manufacturer has redesigned the valve; it may appear different than the original. The updated valve has a new quick connection. To install the updated valve, cut the retaining nut off the existing water line and gently push into the new valve. This is a genuine OEM part. Please remember to disconnect the power and the water supply before starting your repair.

Water fill cup and bearing (refrigerator ice maker fill cup)

The ice maker fill cup and bearing dispenses the water into the ice mold during the fill cycle. If your ice maker is not making ice, is leaking, or the cup or bearing is cracked, you will need to replace this part. This part is three inches long, white in color, and is made of plastic. It is a genuine OEM part. Please remember to disconnect the power and water supply to your refrigerator before starting the repair.

Screw (refrigerator compartment separator screw)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Rock plate (simulated rock grating)

This part is used as a support for the grill element. Sold individually.

Indicator light kit (indicator light kit with red jewel)

This indicator light kit comes with two red jewel light lenses.