2539183512 Kenmore Freezer Parts List

Run capacitor (capacitor)

The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Gasket retainer clip kit - 24 pieces (panel screw)

These are used to hold your gasket in place.

Upper freezer basket - white (basket)

Screw

Sold Individually.

Door light switch (switch)

This is a switch for your refrigerator, but you may also know it as a door switch or a plunger light switch. This part turns your appliance light on and off as the door is opened and closed. If your current light does not turn on, it will need to be replaced. To make this repair you will need a Phillips head screwdriver, a putty knife, and a flat head screwdriver.

Controller kit (controller-r)

Also known as the start relay. This part briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

Filter - drier (filter)

Refrigerant system filter/dryer.

Door hinge (hinge)

Interior drain plug (drain plug)

Drain plug

Light bulb - 25 watt (light bulb)

This bulb can be used in either refrigerator or oven. It is a clear, intermediate screw-in bulb.

Compressor mounting grommet (grommet)

Screw

Compressor kit (comprssr w/o)

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.

Basket