2539284110 Kenmore Freezer Parts List

Door gasket

The door gasket provides an air tight seal, between the door and the freezer, to keep warm air from entering. If your freezer is too warm, frost builds up, or the gasket is torn you may need to replace the door gasket because the freezer will need to work harder in order to cool down. This white door gasket is made of rubber and is a genuine OEM part.

Adjustable leveling foot - black (adjustable foot)

Sold Individually.

Gasket retainer clip kit - 24 pieces (panel screw)

These are used to hold your gasket in place.

White touch up paint (paint-white)

This is an 18 ml bottle of white appliance touch-up paint. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part. Please remember to wear gloves to protect your hands when using this paint.

Shelf support - right side (support)

The shelf support is used to support the right side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf to be uneven and the shelf support will need to be replaced. The support is white in color, measures approximately 1 1/2”, and is made of plastic. This is the right side support only. Left support is not included, must be ordered separately. This is a genuine OEM part and is sold individually.

Shelf support - left side (support)

The shelf support is used to support the left side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color and made of plastic. This is a genuine OEM part and so individually. Note: This is just the left side support. Right support is not included, must be ordered separately.

Screw

Sold Individually.

Door light switch (switch)

This is a switch for your refrigerator, but you may also know it as a door switch or a plunger light switch. This part turns your appliance light on and off as the door is opened and closed. If your current light does not turn on, it will need to be replaced. To make this repair you will need a Phillips head screwdriver, a putty knife, and a flat head screwdriver.

Filter - drier (filter)

Refrigerant system filter/dryer.

Support-rear shelf (rear support)

The rear shelf support is used to support the shelf inside of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color, made of plastic, and measures approximately 1 1/2”. This is a genuine OEM part and is sold individually.

Interior drain plug (drain plug)

Cold control

Also known as Thermostat. This part acts as a safety device against over-heating in case of mechanical failure.

Shelf (trim)

Light bulb - 25 watt (light bulb)

This bulb can be used in either refrigerator or oven. It is a clear, intermediate screw-in bulb.

Vent valve (vent)