2539305193 Kenmore Refrigerator Parts List

Door hinge pin bearing (bearing-hinge, (8))

This white hinge pin bearing pivots the freezer and refrigerator door.

Button plug (plug-button,white,handle/dr stop)

Sold individually.

Filter - drier (drier-filter)

Refrigerant system filter/dryer.

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice from falling back into the mold. Once removed from the mold, the ice is then deposited into the ice bucket, ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The ice stripper is white in color and is approximately 9-inch long. It is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Compressor start relay (relay)

The compressor start relay attaches to the compressor to help start the compressor motor and then shuts off as soon as the motor gets up to speed. The relay is black in color and measures approximately 1”. If your refrigerator is not running you may need to replace the relay. You can use a multimeter to check the continuity. The overload is not included with the start relay. The overload must be ordered separately. Please remember to disconnect the power before starting your repair. This is a genuine OEM compressor start relay.

Hex head screw (screw, ip hex wshr hd,#8(a) x 5/8)

Sold individually.

Cold control thermostat (control-temperature)

This cold control thermostat cycles on and off regularly to maintain a cold temperature in your refrigerator.

Door/light switch (switch-light)

This part turns the light on/off as the door opens and closes.

Crisper pan (pan-crisper,full-width)

Screw (screw-rlr/plate mtg,spcl hx wshr hd,#10-32 x 1/2)

Sold individually.

Water valve with bracket (valve-solenoid/wtr)

The water inlet valve with bracket help supplies water to the water dispenser and ice maker in your refrigerator. If a solenoid goes bad causing no water to enter into the ice maker or dispenser, the water inlet valve will need to be replaced. The bracket on the valve measures 4 3/4”. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Washer (washer,.34 x .62 x .05,nylon)

1/4" x 5/8"

Icemaker thermal cut-off (thermal cut-off asy)

The ice maker thermal cut off acts as a safety mechanism that will shut the ice maker off if the mold heater gets too hot. This part cannot be re-set and must be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Door rack retainer bar (rack door(2))

End caps are sold separately.

Defrost drain pan kit (pan-defrost drain, orig/svce compr)

This kit includes the drain pan, thermal mastic, sound dampening pad and 2 retainer wires. This part mounts to the top of the compressor.