2539639001 Kenmore Refrigerator Parts List

Run capacitor (capacitor)

The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Crisper drawer cover support (crisper support)

This is the replacement crisper drawer cover support for your refrigerator. The crisper shelf rests on the support, which keeps it level. If your drawer cover or shelf will not stay level, or will not stay in place, the support may be damaged. The support is held in place on the refrigerator wall with a drive pin. To remove the damaged support, simply drive the pin all the way in, and use a putty knife to pry the support from the refrigerator wall. At this point, pull the drive pin out and replace the old support with the new one. This is an OEM part and is sold individually.

Defrost thermostat (df limiter k)

The defrost thermostat snaps onto the top portion of the evaporator. It acts as a safety device and protects the evaporator from overheating during the defrost cycle. The thermostat can sense the rise in the evaporator temperature during the defrost cycle and cycles the defrost heater off after all the frost is melted from the coils. This limiter thermostat will cut out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fahrenheit. The defrost thermostat may need to be replaced if the appliance is experiencing temperature-related issues. This is a genuine OEM part. It is recommended to disconnect the power to your appliance before starting your repair.

Evaporator fan blade (refrigerator evaporator fan blade)

If your refrigerator or freezer is too warm or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.

Fresh food door gasket (ff dr gasket)

This white fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Evaporator fan motor kit (motor evaporator)

The evaporator fan motor is in the back of the freezer section and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which then circulates the cold air from the freezer section to the fresh food section. It is suggested to replace the thermistor when replacing the evaporator fan. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.

Hexagonal screw (screw)

Sold individually.

Table-type freezer wire shelf (shelf)

Sold individually. NOTE: For 18 cubic feet refrigerator model order part # 240358005 for the shelf and part# 3201150 end caps, quantity 4.

Door hinge pin bearing (hinge bearing)

This white hinge pin bearing pivots the freezer and refrigerator door.

Filter - drier (filter)

Refrigerant system filter/dryer.

Hex head screw (hex washer head screw)

Sold individually.

Defrost drain pan kit (defrost drai)

This kit includes the drain pan, thermal mastic, sound dampening pad and 2 retainer wires. This part mounts to the top of the compressor.

Defrost heater with straps (heater)

The defrost heater keeps the cooling coils from frosting over.

Fan motor mounting bushing (bushing)

Plug button - white (plug button)