36291211001 Kenmore Range Parts List

Drip bowl - 6 inch (burner bowl)

This 6-inch chrome drip bowl measures about eight inches in diameter at the widest point at the top. This drip bowl is used to catch any drippings or food that falls/spills while cooking. This chrome drip bowl is compatible with most electric ranges that utilize plug-in surface burners. If the drip bowl becomes rusted or damaged, you should replace it to avoid any grease or food that could drop down inside the range. This is a genuine OEM part and is sold individually.

Drip bowl - 8 inch (burner bowl)

This eight inch drip bowl is chrome in color and measures approximately 10 inches in diameter at the widest point. The drip bowl is used to catch anything that may spill over to make cleaning up a little quicker. Over time the drip bowl may become rusty, burnt, or worn down, and will need to be replaced. The drip bowl is a genuine OEM part and is sold individually.

Bake element - push on terminals - 240v (bake element)

The bake element is located on the bottom of the oven with male spade terminals and push-on terminals. The bake element provides heat for baking. If your oven is too hot, not heating evenly, element is not heating, or little to no heat when baking, you may need to replace your bake element. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.

Oven rack

This single chrome oven rack provides a reliable flat cooking surface for your cookware inside of the oven cavity. The oven rack is made of metal and measures approximately 24” wide by 17 1/2” deep. This is a genuine OEM part and is sold individually. Please order quantity needed.

Screw

Broil element - 240v (broil element)

This broil element is found on the roof of the oven.

Drawer support (drawer suppo)

This is a replacement drawer support for your oven. The drawer support provides stability to the drawer unit as it opens and closes. If your oven drawer is hanging or will not slide in or out efficiently, you could have a damaged or missing drawer support. This part is made of white plastic and is sold individually. To replace the support, simply remove the oven drawer, and unscrew the front support on the sides of the oven. Then, simply screw the new part in and replace the drawer to complete your repair.

Screw (screw-1-pk)

Size: 10-32 GXTT FLP .595 Sold individually.

Bracket anti-tip assembly (bracket anti)

8-inch surface element (surface unit)

Surface burner - 6-inch (surface element)

This standard coil element is 6" in diameter with 2 terminal plug-ins.

Indicator light (lamp pilot)

Oven thermostat (thermostat)

This part establishes and maintains the internal temperature of the oven cavity.

Screw

Spacer