59679513013 Kenmore Refrigerator Parts List

Pantry end cap kit, lh and rh (endcap)

The pantry end cap attaches to the inside of the refrigerator cabinet to support the pantry drawer. This is a kit and it includes the left and right end cap. The part is made of plastic, is white in color and measures 24” long. This is a genuine OEM part.

Center rail (rail-centr)

This is the center support rail for the refrigerator crisper drawer. This rail supports center of the crisper frame.

Capacitor (production capacitor)

The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Door gasket - gray (gasket panel)

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Kickplate grille - apollo gray (grille)

This kickplate grille is attached to the bottom of the refrigerator.

Evaporator fan blade (fan blade)

If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Electronic control board (electronic control)

This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.

P-trap drain tube kit (drain tube)

Also known as a duck bill. This kit includes the tube extension piece and spacer.

Freezer evaporator fan motor - 115v 60hz (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will covert the heat into cool air, which is then circulated.

Door shelf bin (cantilever bin)

Sold individually.

Frame

Damper control assembly (control)

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Touch-up paint - black (tuchup)

16ml