66513962K014 Kenmore Dishwasher Parts List

Elbow hose fitting (dishwasher water inlet fitting. Has standard 3/4 inch hose thread on one end and 3/8 inch copper tubing on the other. Copper tubing fitting is compres)

This part has a swivel gooseneck fitting and that allows it to be installed closer to the wall. This part has a 3/4" hose thread on one side and a 3/8" copper tubing on the other side.

Turbidity sensor (turbidity sensor mounted in pump sump under dishwasher)

Measures level of soil in the water.

Shield (toe panel insulation)

Shield

Upper rack wheel (upper dishrack wheel)

Sold individually.

Overfill control switch (float switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Tub cap (plug, tub)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Spring grip retainer (retainer, spring grip)

Water inlet (water inlet into dishwasher)

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Tub sound shield - insulation (tub sound shield)

Clip (dispenser door rack guard)

This OEM dishrack guard clip fits on the front of the upper dishrack and acts as a bumper between the rack and inner door panel. This guard clip is approximately 3 inches long and made of plastic. To replace this part, open the dishwasher door and then slide the upper dishrack out, then simply unclip the faulty guard clip before fastening the new one.

Dishwasher screw (screw)

Sold individually.

Thermostat (safety thermostat)

Diverter motor with wire harness (pump diverter motor. Seal for diverter motor shaft only available with the pump sump housing.)

NOTE: This part has been updated by the manufacture and the shaft seal is now incorporated into the sump housing. The seal for diverter motor shaft only available with the pump sump housing.

Screw

This part is a replacement screw for your dishwasher. It is made of metal and is approximately ¾ inch long. It is a hex-head screw and is sold individually. It is used to hold the dispenser bracket in place. This part is a genuine OEM part sourced directly from the manufacturer.