66512413N413 Kenmore Dishwasher Parts List

Rack track stop

This gray rack track stop is used for your upper dish rack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.

Dishwasher heating element

The heating element is used to create heat during the dry cycle and increase water temperature during portions of the wash cycle when certain options are selected. If your dishes are not drying or the water in the dishwasher is not getting hot you may need to replace the element. This kit includes the heater, two heater fasteners, and is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Mounting bracket

The mounting bracket is used to attach the dishwasher to the underside of the counter. The mounting bracket holds the dishwasher in place to keep it from moving during cycles and to keep the dishwasher level. The bracket is made of metal and is approximately 3” in length. The screws are not included with the bracket, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the dishwasher before starting the repair.

Upper rack roller

Retainer clip - black

This part is used to hold the access panel in place. Sold individually.

Friction sleeve

The friction sleeve helps to reduce friction between the door hinge and the door and to keep your door quiet when it opens and closes. This part is a little over an inch long and is black in color. It is sold individually.

Dishwasher inlet valve

This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Dishwasher filter

This filter works with the water pump in your dishwasher. It prevents debris from entering the pump and causing damage. As a result, the filter can occasionally become clogged or damaged, and will need to be replaced. A good indication of a damaged filter is if your dishwasher is not draining or cleaning the dishes properly. This filter has a gray plastic top and bottom that are approximately 5 inches in diameter. This is a genuine OEM part that comes directly from the manufacturer. To replace the filter, simply turn it counterclockwise to unlock, and then screw in the new filter

Drain hose

This part is used to drain water from your dishwasher.

Drain hose

This drain hose is 6 and 1/2 feet.

Cover screw

Sold individually.

Spray paint - 12 oz. - white

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

High limit thermostat

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Push-in retainer clip

Sold individually.

Silverware basket

This silverware basket sits in the lower dishrack and holds small utensils like forks, knives, and spoons during the dishwashing cycle. The basket is made of high quality grey plastic and measures approximately 19 inches (length) x 8 inches (height) x 4 inches (deep).